PPR管材管件-Gafloon-南平PPR管材管件

PPR管格与管件连接端面必须清洁、干燥、无油。

用卡尺和合适的笔在管端测量并标绘出热熔深度，热熔深度应符合下表规定：

熔接弯头或三通时，按设计图纸要求应注意其方向，在管件和管材的直线方向上，用辅助标志标出其位置。

The connecting end face of PPR pipe lattice and pipe fittings must be clean， dry and oil-free.

Measure and plot the hot melt profundity at the pipe end with a caliper and a suitable pen. The hot melt profundity shall meet the requirements of the following table:

When welding elbows or tees， the direction could be noted according to the requirements of design drawings， and the place shall be marked with auxiliary marks in the straigh*rection of pipe fittings and pipes.

冷热水管不要同槽

水路改造时，冷热水管要不要同槽，而且两者之间距离保持10cm以上。如果热水管紧挨冷水管，会降低热水管的保温性，热水很快就会变冷。这里还要提醒大家，水管开槽较深，要避免开开横槽，横槽会*墙体结构。

In waterway rectruction， whether the cold and hot water pipes should be in the same groove， and the distance between them should be kept at least 10 cm. If the hot water pipe is close to the cold water pipe， the heat preservation of the hot water pipe will be reduced， and the hot water will soon become cold. Here also reminds everybody， the water pipe groove is deep， must *oid to open the transverse groove，PPR管材管件， the transverse groove will destroy the wall structure.

PPR 管材与 PPR 塑件连接，是常见的连接方式，通常大家听到的，PPR管材管件制造，ppr 管材热熔连接，就是说的这种方式，我们经常见到的，直接连接，大多采用 PPR 管和直接塑件进行热熔连接，ppr 管材，南平PPR管材管件，与 PPR 嵌件伸缩节，可直接进行热熔承插连接。

PPR pipe and PPR plastic parts connection， is a common way of connection， usually you hear， PPR pipe hot-melt connection， that is to say，PPR管材管件厂家， this way， we often see， direct connection， mostly using PPR pipe and direct plastic parts for hot-melt connection， PPR pipe， and PPR insert expansion joint， can be directly hot-melt socket connection.