PISO-CAN400U通用PCI总线4口隔离CAN通讯卡

<*n style="color:#ff0000"><*n style="font-size:12pt">价格说明

<*n style="font-size:12pt">此价格为含税价格，订单中税费无需*统计。其他综合需求，请与我们联系。

<*n style="font-size:12pt">联系电话：18516008375、

<*n style="font-size:12pt">意见直通车

<*n style="font-size:12pt">如果您有任何意见或建议，请拨打18516008375 、021-80399544告诉我们

<*n style="font-size:12pt"> 

<*n style="color:#ff0000; font-size:14pt"><*n style="color:#ff0000">产品概述 通用PCI总线4口隔离CAN总线通讯卡、CAN口为DB9针接头
 

<*n style="font-size:12pt"> The CAN (Co*oller Area Network) is a serial communication protocol, and efficiently supports distributed real-time co*ol with*ery high level of security. It is an especially suit for networking "intelligent&quo*vices as well as sensors and actuators within a system or sub-system. In CAN networks, there is no addressing of subscribers or stati* in the conventional sense, but instead prioritized messages are tran*itted. As standalone CAN co*oller, PISO-CAN400/CAN200 can represents an economic solution of an active CAN board. It has two or four independent CAN bus communication ports with 5-pin screw terminal connector or 9-pin D-sub connector, and has the ability to cover a wide range of CAN applicati*. Besides, PISO-CAN400/CAN200 uses the new CAN co*oller Phillips SJA1000T and transceiver 82C250/251, which provide bus arbitration, error detection with auto correction and re-tran*ission function. It can be installed in a 5V PCI slot and supported truly “Plug & play”.
 

• <*n style="font-size:12pt">Two independent CAN bus 2.0A/2.0B communication ports
• <*n style="font-size:12pt">Compatible with CAN specification 2.0 parts A and B
• <*n style="font-size:12pt">On-board optical isolation protection
• <*n style="font-size:12pt">Programmable transfer rate up to 1 Mbps
• <*n style="font-size:12pt">2500 Vrms photo couple isolation on the CAN bus
• <*n style="font-size:12pt">Jumper select 120Ω terminator resistor for each port
• <*n style="font-size:12pt">Direct memory mapping to the CAN co*ollers
• <*n style="font-size:12pt">33MHz 32bit 5V PCI bus (V2.1) plug and play

• <*n style="font-size:12pt">Can be a CAN system monitor tool with CAN ca*
• <*n style="font-size:12pt">It is a good tool to test CAN system
• <*n style="font-size:12pt">Send/Receive/Record CAN messages.
• <*n style="font-size:12pt">Provide cyclic tran*ission function
• <*n style="font-size:12pt">Record the CAN messages with filtered ID and time stamp
• <*n style="font-size:12pt">Support: Win98/Me/2000/XP-32bit/7-32bit/7-64bit (not for Win 7 Ultimate-64bit)

<*n style="font-size:12pt">